LEO

Leo VAV is a complete measuring and control unit where the air flow rates in ventilation systems can be set as required. At the measuring station, the differential pressure is measured via measuring rod integrated in the unit. The unit is installation-friendly in terms of straight ducting, and can thus be mounted in most ductwork sections. It is fully compliant with air permeability class 4 for damper in closed position, and class C for leakage to the surroundings. Leo is equipped with VAV controller from Belimo or Siemens.

Belimo LMV-D3-FK AU is used from dim. 100 to dim.400.                              Belimo NMV-D3 AU is used from dim. 500 to 630.                                      Siemens GDB181.1E is used from dim. 100 to dim.315.                              Siemens GLB181.1E is used from dim. 400 to dim. 630.                            Controller specifications are provided in table 1.                                                  Full technical documentation can be downloaded from our website      www.trox.no.                                                                                                Belimo LMV/NMV-D3 is used as analog control or for MP-bus.                      Belimo LON or MOD/BACnet controller or Siemens BACnet controller is also available.                                                                                                            For KNX, Belimo LMV-D3-KNX and NMV-D3-KNX or Siemens GDB181.1E/KN and GLB181.1E/KN is available.                                                                                    If additional protection against structure-borne noise is required, e.g. for open installation, the unit can be delivered with external insulation and casing. This will reduce the level of noise emitted from the actual unit at high choke pressure and high velocity past the damper. However, this should be followed up with additional protection against structure-borne noise from the duct at both sides of the unit. Please see acoustic datasection. The LEV sound attenuator is designed for VAV systems, and is available in 500mm and 1000mm lengths. LEV has a full attenuator cross-section, and this ensures a low-level pressure loss. It is insulated with mineral wool featuring a reinforced top layer to prevent fibres breaking away with the supply air. An extraction unit with mesh grille, ASN, in the same design as LEV is also available. Leo-D, LEV and ASN can be delivered pre-assembled with ducting clips and are equipped with adjustable brackets from factory.